Archive - 2009 - Forum topic
November 15th
IGate with UISS
Is there anyone who has successfully setup IGate with the great program UISS??
I have downloaded the proper add-on, but somehouw the validation seems to be wrong.
The setting is as following:
Callsign: PE1PQX (my own callsign off course)
- Host: satgate.aprsca.net
- Validation: -1 (<--- seems to be invalid...?)
- Port: 14580
- filter: p/ISS/W3ADO
I use no proxy here.
Any suggestions???
Thanks!!
November 14th
stations conected on message borard system
*** CONNECTED to RS0ISS-11
Welcome to RS0ISS's message board
System Ver 1.50 107762 Bytes free
CMD(F/K/M/R/W/B/H/?)>
EA2AUK 19:47:15
IW0FKO-1 19:49:54
RA3UD 19:53:08
PD0RLX 22:58:35
IW0FKO 23:00:39
KB1GVR 00:24:42
IZ7GEG 00:36:58
EA5HGE 02:10:46
VK6IQ 05:54:04
VK6CO 07:32:30
LW1DXP 13:20:55
UA9UIZ-6 14:02:25
LW4DEM 14:58:00
CX4DAR 14:58:22
JJ1TJV 15:51:30
LW5DGM-6 16:35:03
LU4EYG 16:35:22
PY4MAB-1 16:38:09
CMD(F/K/M/R/W/B/H/?)>
November 12th
ALOGGER
Hi is any one running alogger program if so did you get validation code so that you can inject packets to aprs-is.
regard's les. 2e1ebx
November 9th
iss over north italy
73' to all, i'm in3izq danilo from north italy, i have heard iss on aprs .
its fantastic,
i use uiview and tm 751 with vertical antenna.
November 3rd
Today ISS active over South America
Roland, PY4ZBZ post this message ( 11/03/2009 ) in ISS FAN CLUBE BRAZIL Forum:
" Listened to the ISS on voice 19:40 UTC, probably
as part of a telebridge. Too bad it only recorded
end,the ISS to only 20 degrees elevation. In 145,800 kHz."
The recording can be heard here:
or
http://www.qsl.net/py4zbz/satelite/iss1458.wav
Thanks Roland
73
Piraja, PS8RF
October 30th
CONECTED OVER BRASIL
*** CONNECTED to RS0ISS-11
Welcome to RS0ISS's message board
System Ver 1.50 110816 Bytes free
l
CMD(F/K/M/R/W/B/H/?)>
Msg# Size TS Date Time From To @ BBS Subject
10 410 05-Dec/1936 LW6DC >ALL Hello fans ISS
3 170 04-Dec/0256 CM6JAR>ALL
110816 Bytes free
Next message Number 15
CMD(F/K/M/R/W/B/H/?)>
*** CONNECTED to RS0ISS-3
RS0ISS-3>P0PPP0,SGATE,WIDE :ISS Crew Keyboard. Crew may not be available. For BBS/PMS use RS0ISS-11
MAURICIO BERALDO PY4MAB
py4mab@amsat.org
BRAZIL
October 27th
APRS Settings
Hi All,
Sorry if this has been asked many times before however I have just acquired a Big Red Bee APRS TX and GPS in one. I have programmed the paths as ARISS & SGATE.
Tonight the ISS went directly overhead my place and I heard the ISS sending packets. My BRB was TX'ing however I was neber picked up at all. Pass lasted around 10 mins.
Is there another path I should be using specifically for the ISS APRS? The ISS is only what im interested in whilst travelling...
73's, Duncan - VK6GHZ
APRS Settings
Hi All,
Sorry if this has been asked many times before however I have just acquired a Big Red Bee APRS TX and GPS in one. I have programmed the paths as ARISS & SGATE.
Tonight the ISS went directly overhead my place and I heard the ISS sending packets. My BRB was TX'ing however I was neber picked up at all. Pass lasted around 10 mins.
Is there another path I should be using specifically for the ISS APRS? The ISS is only what im interested in whilst travelling...
73's, Duncan - VK6GHZ
October 11th
New and question.
Hi!!! I'm new to this forum so to ISS radio contact. In fact I will try my first contact tomorrow October 12. My callsign is KJ4EBE.
My question is the next. It is possible to listen the ISS with a handheld and a 5/8 telescopic antenna??? If it is so, what about been received by the ISS ???
Thank you.
October 8th
Question about message
Today I was sent a message via ARISS and I replied back. The message kept coming same as the first time...Never had that happen before. ISS had to get out of range for it to stop.